Brightness Problem on Chrono Trigger NEED HELP

[chronodude1]

This may sound like a really newbie question but when I am in the sewers in 2300 AD I can't see anything. How can I raise the brightness or can I not? I have tried 1, 2, 3, and 4 and I have looked all around but I can't figure it out. Please help me I really don't want this problem!

[Jale]

Post a screenshot so we can see. If you are using ZSNESW, press F1 and then "Save snapshot". Upload it and show.

[chronodude1]

okay I got the snapshot saved but I can't find it where do I get it?

[chronodude1]

i can't get the pic on I found it but I can't copy and paste it on. How do I upload it on?

[Jale]

Upload here: http://www.imageshack.us. There you will get a link to your uploaded picture and paste the link here.

[chronodude1]

http://img139.imageshack.us/img139/8051/image77tp.png

here you go, all I can see is Crono and Robo and Marle (behind Crono)

[Jale]

I must say it's your monitor's brightness because I can see the sewer environment. Normally it's dark because it's... a sewer. Try adjusting your monitor's brightness.

[chronodude1]

my monitors brightness is at 100 and I can see dim outlines of the sewer but i have played emulations that allowed me to see a lot more than that. Everything is dimmer than what I have played before.

[Jale]

Then check your video card's gamma; I think it's set too low. It's strange, because I can see the sewer even with the brightness set to 40%.