Zach said:
If you're referring to my "temporary" fix of my Zenith, couldn't afford much back then pal, working my ends off for a bit of money. It was either "deal with it" or "do with out". Life's too damn short to let stuff like that get to you though, I mean, getting shocked by the TV was least of my problems, but laughing it off isn't any more harm done. If I survived that, guess I still have a bit of purpose to still be in this world...
ulaoulao said:
Quote:
Not sure what this garbage means, but sounds similar to my issue, though problem: never changed the "refresh rate" nor "resolution" since I set the thing up, so don't know what was changed, though tried other rates and resolutions and still no difference. So far for the last two days - nothing from the monitor, just a blank display...
- merely coincidental. That just means your "res" for example out of scope with the lcd..
Quote:
Not sure what you mean by that
- I would no t be shocked if someone found a way to rig up a on off button.
Guessing the manual has nothing to do with my issue then...
Anyhow - opened the LCD to peek around a bit. Basically a flat metal casing with wire connectors and chip boards on the back. From the power source connector, it runs into the circuit board and that to the two connectors into the LCD face panel itself. From the VGA connector, it runs up to the controller board and that to again the circuit board. Pretty much everything in there is "disconnectable" but not much difference by running the VGA connector "by-passing the controller board" just to the circuit. Looks like nothing much to play nor experiment with...
Appreciate all the suggestions bud.
I'm surprised of the content posted so far, which helps, but looks like it's hopeless...
If I come up with something new, be sure to post...