PJ64 controller analog stick sensitivity

[regnad]

I'm using PJ64 1.6.

My analog stick seems to be all or nothing -- for example when I play Mario 64 or Banjo Kazooie, the character is either running or stopped. I can't seem to get it to walk slowly.

I've gone to the configuration menu and played with analog range, and when I crank it down, the character goes from running/stopped only to walking/stopped only. Again, there seems to be no range of speed.

Do I have a crappy controller? Or is this a typical problem? Or is it easily solved?

Anyone else had/have this problem?

[regnad]

Do you think the N-Rage plugin would help solve this problem? Does anyone use it?

[ulaoulao]

Either plug in works read here

[regnad]

Hmmm...

I went the the above post, read it, installed N-Rage plugin, played with the sliders, and it's still the same problem. No change.

This persistent problem makes playing Banjo, Mario, Conker, and a lot of other platformers frustratingly difficult -- to the point where I often have to go to the menu and adjust the slider bar while playing the game when it's necessary to walk slowly.

Anyone have any suggestions?

[ulaoulao]

What joy stick do you have? Are you using an analog stick?

[regnad]

I live in Japan, so the brand may be unfamiliar to you.

Its a Sanwa, and it does have an analog stick of course.

Any recommendations for any controllers that in fact do work well? Or any plugin other than N-Rage that might do the trick?

Thanks in advance for any help!!

[ulaoulao]

See your other post..